With any project, proper planning is the first and most important step. A remodeling project is no different. If you are installing moulding, the surfaces have to be very clean and smoother. You have to be ready to cut the molding and therefore have the right tools handy, such as a mitre box, clamps and a cope saw. Finishing material and finishing nails will also have to be at hand.
The purpose of a mitre box is to hold pieces of wood at a correct angle to be cut. They may come in different sizes and shapes, but they all serve this same purpose. Even if you are using pre-molded trim, you will have to make joint cuts at 45 degree angles.
When you are doing the trim in a room, measure hate entire room and then add for any cutting losses. It is easy to make a piece shorter, impossible to make it longer without seaming two pieces together, which will not look as good.
https://www.haohaomould.com/product/auto-mould/car-blade-mould.html
Moulding pieces are joined together at 45 % angles at corners or anywhere else there is not a straight run.
Take a lot of care doing the corners, since errors show readily here. You can make this easier in a number of ways. If you make the pieces end a little before the corner, you can use small rounded premade cuts to fill. Or, make the corner as best you can and then fill with wood putty and sand it down well.
No home is exactly square and level, so expect irregularities when you are working with moulding. You can join pieces together by hammering finishing nails at the ends or glue them together on the joined surface. If you do use nails, make sure to nail them in at a different level on one piece than the piece next to it. This way, you will not be hammering a nail into a piece right on the adjoining piece, which will cause the wood to crack.
You may still have some of the trim crack on you. If you press on the surface with a piece of plastic or wood, this will prevent this cracking. This will push the nail into the wood, instead of going outward to form a crack.
The purpose of a mitre box is to hold pieces of wood at a correct angle to be cut. They may come in different sizes and shapes, but they all serve this same purpose. Even if you are using pre-molded trim, you will have to make joint cuts at 45 degree angles.
When you are doing the trim in a room, measure hate entire room and then add for any cutting losses. It is easy to make a piece shorter, impossible to make it longer without seaming two pieces together, which will not look as good.
https://www.haohaomould.com/product/auto-mould/car-blade-mould.html
Moulding pieces are joined together at 45 % angles at corners or anywhere else there is not a straight run.
Take a lot of care doing the corners, since errors show readily here. You can make this easier in a number of ways. If you make the pieces end a little before the corner, you can use small rounded premade cuts to fill. Or, make the corner as best you can and then fill with wood putty and sand it down well.
No home is exactly square and level, so expect irregularities when you are working with moulding. You can join pieces together by hammering finishing nails at the ends or glue them together on the joined surface. If you do use nails, make sure to nail them in at a different level on one piece than the piece next to it. This way, you will not be hammering a nail into a piece right on the adjoining piece, which will cause the wood to crack.
You may still have some of the trim crack on you. If you press on the surface with a piece of plastic or wood, this will prevent this cracking. This will push the nail into the wood, instead of going outward to form a crack.
コメント